Stallion ST-317 DT-51329-A Driveshaft Remover Adapter Tool Alt
Driveshafts on upcoming AWD vehicles are retained by a retaining clip inside the splines, which locks onto the PTU or RDM splined shaft. In order to overcome the retaining ring, a large force must be applied against it suddenly.
Current retention force of the PTU is 350-450N with possibility of increasing in the future. Attempts to pry the driveshaft off the PTU or RDM will damage the driveshaft. To prevent damage to the driveshaft, DT-51329-A fits the groove provided on Equinox, Terrain, XT5, Acadia, and Envision prop shafts, and is used with previously Essential J-02619-A slide hammer to unseat the snap ring. DT-51329-A attaches around the propshaft, and its two halves are tightened together to seat DT-51329-A into the groove. The slide hammer is then attached, and used to remove the propshaft. The removal force is 2000-6000N @ 50mm/min. Unapproved methods will damage the prop shaft.
Application:
Chevrolet Equinox
This tool comes with a lifetime warranty!
For Chevrolet
Tools Catalog click here
Looking
for a different Chevrolet Tool? Please give us a call!! (909) 334-4400
Shop hard to
find auto parts, high-end electrician tools, specialty auto-shop supplies and
forestry tools at affordable pricing with FREE Selected Shipping. We specialize
in auto, aviation, boat & motorcycle, serving the institutions of military,
government, emergency response & education for over 50 years. Find
vehicle-specific tools, as well as DIY, boutique hand tools, specialty
motorcycle tools to get the job done right.